Independent ALSA and linux audio support site

Gusclassic

From the ALSA wiki

Jump to: navigation, search

gusclassic

The following IRQs are valid with the gusclassic driver: 2,3,5,7,9,11,12,15. However 2,3,7,15 are normally used in an ISA system, if you use a ps/2 mouse 12 as well. This leaves you with 5 and 11 as valid interrupts. I recommend 5 when you have no other ISA card installed. Be sure to mark this interrupt as used by a native ISA hardware in your bios setup.

The following DMAs are valid with the gusclassic driver: 0,1,3,5,6,7. 0,1 and 3 are 8bit DMAs, 5-7 are 16bit. I recommend you use DMA 6 and 7 with your GUS. You will have to declare them used by ISA in your bios setup as well.

These IRQ and DMA restrictions apply to all GF1 based GUS cards, thus also to GUS Max and GUS Extreme. (but I haven't verified yet)

My module options for my GUS classic look as follows:

options snd-gusclassic port=0x240 irq=5 dma1=6 dma2=7

Retrieved from "http://alsa.opensrc.org/Gusclassic"

Category: ALSA modules